TM 9-1240-271-34&P
4-20.
PLATE ASSEMBLY ASSEMBLY (CONT)
I
--
Step
Procedure
1.
Install two plunger assemblies (1) into plate (2).
NOTE
When installing shaft (3), check that shaft holes in
plungers (1) are in line and flat center part of shaft (3)
is at open side of plate (2).
2.
Put a small amount of grease on shaft (3) (JPG).
NOTE
It may be necessary to move plungers (1) to allow
installation of shaft (3).
3.
Install shaft (3) into plate (2) making sure keyed end of shaft (4) is on same side as
lever plunger (5). Push shaft (3) into plate (2) Far enough to put on collar (6).
4.
Put collar (6) on end of shaft (3) and line up holes.
NOTE
Pins (7) and (8) are tapered and can be installed one
way only. Line up scribe marks made in disassembly.
5.
Using hammer, install pin (7). Push shaft (3) into plate (2) until collar (6) is against
plate (2).
6.
Place key (9) in keyway of shaft (3) and slide or tap gently lever assembly (10) over
end of shaft (3).
7.
Using hammer, install pin (8).
8.
Using Allen wrench, remove two 10-32 x 5/8 screws (11).
9.
Using open end wrench, install two self-locking screws (12).
GO TO FRAME 8
Para 4-20 Cont
4-38
Vol II
