TM 9-1240-271-34&P
4-20.
PLATE ASSEMBLY ASSEMBLY (CONT)
Procedure
Step
2).
1.
Put small amount of grease on spring (1) and plunger
Put spring (1) into plunger (2).
2.
Put plunger (2) with spring in bracket (3).
3.
Put arm (4) with flat side over plunger (2).
4.
Line up hole in arm (4) with hole in bracket (3) and hold in place.
5.
Using fingers, start pin (5) in hole. Using ball peen hammer, install pin (5) through
6.
bracket (3) and arm (4).
Install support (6) into arm (4) and put on washer (7).
7.
Using retaining ring pliers, put retaining ring (8) on support (6).
8.
GO TO FRAME 4
Para 4-20 Cont
Vol II
4-34
