TM 9-1240-271-34&P
4-20.
PLATE ASSEMBLY ASSSEMBLY (CONT)
Procedure
Step
--
NOTE
Install plunger (2) with beveled edge facing out.
1.
Place spring (1) into plunger (2) and slide both into plate (3) so that slot in plunger (2)
is in line with pin hole in plate (3).
Usng fingers, hold plunger (2) in plate (3).
2.
Using 1/8" screwdriver, press against the end of spring (1) until spring (1) is clear of
3.
slot in plunger (2). Hold screwdriver with same hand that is holding plunger (2).
Using fingers, install pin (4) into hole in plate (3).
4.
Using hammer, tap in through plate (3). and plunger (2) until it holds spring. Remove
5.
1 /8" screwdriver, and using hammer and punch, drive pin all the way in.
GO TO FRAME 6
Para 4-20 Cont
Vol II
4-36
