TM 9-1240-216-34
Section 6. HIGH VOLTAGE CABLE ASSEMBLY
HIGH VOLTAGE CABLE ASSEMBLY MAINTENANCE PROCEDURES INDEX
4-19.
Reference (para)
Step
Removal
Installation
HIGH VOLTAGE CABLE ASSEMBLY REMOVAL
4-20.
TOOLS: 3/16" flat tip screwdriver
PERSONNEL: One
EQUIPMENT CONDITION:
Body assembly on work bench with head assembly removed:
power supply disconnected
PRELIMINARY PROCEDURES:
Remove terminal board assembly on each side of body assembly
NOTE
Frame 1 is for M19 and M24 old configurations, Frame 2
is for M19 and M24 new configurations.
FRAME
1
Step
Procedure
1.
Using screwdriver, unscrew long screw (1) and short screw (2) until clear of body
assembly (3), Do not remove.
2.
Lift terminal housing (4) from body assembly (3).
Remove short screw (2) and lockwasher (5) from terminal housing (4).
3.
4.
Remove long screw (1) slowly and remove spacer (6), ground wire and lockwasher (7).
5.
Hold board assembly (8) and slide terminal housing (4) off.
Using screwdriver, remove screw (9), lockwasher (10), and cable terminal A from
6.
terminal (11) of board assembly (8).
7.
Unscrew receptacle cap (12).
Do steps 1 thru 6 again to disconnect cable terminal B of cable assembly (13) from
8.
terminal housing (14) on both sides of body assembly (3).
Para 4-19
4-34
Vol II