TM 9-1240-216-34
BOARD ASSEMBLY AND GROUND WIRE ASSEMBLY INSTALLATION
4-18.
(CONT)
NOTE
This procedure is for installation of either board assembly.
FRAME 2
Procedure
Step
NOTE
If ground wire is the only item to be installed, go to step
4.
1.
Place screw (1) through lockwasher (2) and tagged wire terminal lug (3).
Using screwdriver, put screw (1) into terminal (4) of board assembly (5) while making
2.
sure the numbers on, the tags match the number of the terminals (4).
Remove tags from the wires.
3.
4.
Using screwdriver, install screw (1), lockwasher (2) and ground wire to board assembly
(5).
5.
Slide terminal housing (6) over board assembly (5).
6.
Place long screw (7) through lockwasher (8), board assembly (5), spacer (9), and
terminal housing (6).
Place terminal housing (6) in body assembly (10).
7.
Using screwdriver, put in and tighten long screw (7) into body assembly (10).
8.
Place short screw (11) through lockwasher (12) and terminal housing (6).
9.
Using screwdriver, put short screw (11) into body assembly (10).
10.
NOTE
FOLLOW-ON MAINTENANCE
END OF TASK
Para 4-18 Cont
4-32
Vol II