TM 9-1240-216-34
BOARD ASSEMBLY AND GROUND WIRE ASSEMBLY INSTALLATION
4-18.
TOOLS: 3/16" flat tip screwdriver
PERSONNEL: One
EQUIPMENT CONDITION: Body assembly on work bench with head assembly removed;
power supply disconnected
NOTE
Frame 1 is for M19 and M24 new configurations. Frame 2
is for M19 and M24 old configurations.
NOTE
This procedure is for either the left-hand or right-hand
board assembly, but only the right-hand side has ground
wire.
FRAME 1
Procedure
Step
1.
Using screwdriver, install wires (1) and (2), washer (3), and screw (4) on terminal board
(5).
Remove tags from wires.
2.
Using screwdriver, install ground wire (6), washer (7), and screw (8).
3.
Slide terminal board housing (9) over terminal board (5) until you feel the board (5)
4.
slip into a slot inside the housing (9).
Place long screw (10) through lockwasher (11), ground wire (6), board assembly (5),
5.
spacer (12), and terminal housing (9).
Place short screw (13) through lockwasher (14) and terminal housing (9).
6.
Place terminal housing (9) into body assembly (15).
7.
Using screwdriver, tighten short screw (13) and long screw (10) into body assembly (15).
8.
NOTE
FOLLOW-ON MAINTENANCE
Install cover (para 4-15).
Do checkout procedure (Vol I, para 2-2).
END OF TASK
Para 4-18
Vol II
4-30
