TM 9-1240-401-34&P
2-13. CABLE ASSEMBLY MAINTENANCE INSTRUCTIONS - continued
c. Assembly - continued
14
Install two insulation sleevings(16) on leads of ca-
ble (9).
Install two electrical contacts (15) on bushing insu-
15
lator (7); then install two lug terminals (11) on two
electrical contacts (15) by installing two nuts (14).
16 Install new gasket (1 3), angle bracket (1 O), and
new gasket (12) on bushing insulator (7).
17 Solder cable (9) leads on two lug terminals(11)
using solder and flux. Refer to wiring diagram and
check continuity of cable assembly.
18 Slide electrical shell connector (8) along cable to-
ward angle bracket (10) and secure with four new
Iockwashers (6) and four machine screws (5).
19 Install receptacle shell (4) and plate (3) on bushing
insulator (7) and secure with shoulder pin (2) and
machine screw (1).
20 Tighten bushings (17 and 22).
