TM 9-1240-285-34&P
Section 8. SLIDE ASSEMBLY AND BOOTS
SLIDE ASSEMBLY AND BOOTS MAINTENANCE PROCEDURES INDEX
Reference (para)
Task
Removal
Installation
SLIDE ASSEMBLY AND BOOTS REMOVAL
TOOLS:
9/ 16" box wrench
9/64" socket head screw key (Allen wrench or equivalent)
9/ 16" flat tip screwdriver
1/4" brass drift pin
Soft face hammer
4 oz. ball peen hammer
Long nose pliers
PERSONNEL: One
EQUIPMENT CONDITION: Telescope mount on work bench
Remove deflection boresight adjusting mechanism (para 4- 14)
PRELIMINARY PROCEDURES:
Remove holder assembly ( para 4- 17)
FRAME 1
Procedure
Step
1.
Using 9/ 16" wrench, remove two screws (1), two lockwashers (2) and two flat washers
(3) from side of teleseope mount housing (4).
2.
Using ball peen hammer and drift pin, remove housing assembly (5) from slide assembly
(6).
NOTE
All new type boots (7) and (11) with lacing wire (8)
and grommets (9) are removed in the same way.
If boot (7) is new type, go to step 3. If boot (7) is old
type, go to step 5.
3.
Using long nose pliers, remove lacing wires (8).
4.
Remove four grommets (9).
5.
Carefully remove boot (7).
Vol II
