TM
9-1240-285-34&P
SLIDE ASSEMBLY AND BOOTS INSTALLATION (CONT)
4-23.
NOTE
If boot (1) is new type with lacing wire (2) and
grommets (3), go to step 1. If boot (1) is old type, go to
step 8.
1.
Put boot (1) on shaft of slide assembly (4). Put four grommets (3) on boot (1).
2.
Put slide assembly (5) into housing (6) so that boot (1) is seated in groove in shaft of
s l i d e assembly (4) and groove in housing (6).
3.
Using long nose pliers, put lacing wire (2) into boot (1). Make sure that boot (1) stays
seated in grooves.
Put boot (7) on shaft of slide assembly (4).
4.
5.
Put four grommets (3) in boot (7).
6.
Seat boot (7) in groove in shaft of slide assembly (4) and groove in housing assembly
(8).
7.
Using long nose pliers, put lacing wire (2) into boot (7). .Make sure boot (7) stays
seated in grooves. Go to step 11.
8.
Put boot (1) on shaft (4) of slide assembly (5).
9.
Put slide assembly (5) into housing (6) so that boot (1) is seated in groove in shaft (4)
of slide assembly (5) and groove in housing (6).
10.
Seat boot (7) in groove in shaft (4) of slide assembly (5) and groove in housing
assembly (8).
11.
Using 9/16" wrench, install two screws (9), two lockwashers (10) and two flat washers
(11) to hold housing assembly (8) in place.
12.
Using soft face hammer, tap plug (12) in housing assembly (8).
NOTE
FOLLOW-ON MAINTENANCE
Install deflection boresight adjusting mechanism (para
END OF TASK
4-46
Vol II