TM 9-1240-285-34&P
HOLDER ASSEMBLY ASSEMBLY
TOOLS: Long nose pliers
4 oz. ball peen hammer
5/ 16" and 1/8" socket head screw key (Allen wrench or equivalent )
Center punch
PERSONNEL: One
Installing cotter pin
REFERENCES: JPG 4lC for:
Staking
EQUIPMENT CONDITION: Telescope mount on work bench
FRAME 1
Procedure
Step
1.
Line up clamp (1) with holder (2).
2.
Using hammer, put pin (3) through clamp (1) and holder (2). Using hammer and center
punch, stake both ends of pin (3) (JPG).
3.
Place pivot (4) on screw (5) and put screw (5) through clamp (1) and holder (2).
4.
Put sleeve nut (6) on screw (5). Make sure threaded hole of sleeve nut (6) is facing the
flat surface of holder (2).
Using 5/16" Allen wrench, tighten screw (5).
5.
Using 1/8" Allen wrench, install disk (7) and screw (8).
6.
7.
Using long nose pliers, install cotter pin or spring pin (9) (JPG).
END OF TASK
Vol II
