TM 9-1240-285-34&P
4-18.
HOLDER ASSEMBLY DISASSEMBLY (CONT)
Step
Procedure
NOTE
Some holder assemblies may have a spring pin instead
of a cotter pin (1). Spring pin should be removed with a
5/16" punch.
1.
Using long nose pliers, remove cotter pin (1) from screw (2) on holder assembly (3).
2.
Using 1/8" Allen wrench, remove setscrew (4) and plastic disk (5).
3.
Using hammer and 1/4" punch, drive out pin (6).
4.
Using 5/16" Allen wrench, remove screw (2), sleeve nut (7) and clamp (8).
5.
Remove pivot (9) from screw (2).
END OF TASK
Para 4-18 Cont
4-37
Vol II
