TM 9-1240-271-34&P
PLATE ASSEMBLY DISASSEMBLY (CONT)
4-19.
FRAME 3
Procedure
Step
Pull out grip assembly (l).
1.
NOTE
Pin (2) is tapered and can only be removed one way.
2.
Using hammer and 3/32" punch, remove pin (2). Scribe mark on lever (3) and. shaft
(4) to line up holes for assembly.
3.
Using hammer and brass drift pin, remove lever (3) from shaft (4) and remove key (5).
4.
Using hammer and 3/32" punch, remove pin (6). Scribe mark on collar (7) and shaft
(4) to line up holes. Slide collar (7) off end of shaft ( 4).
NOTE
Plunger assemblies (8), (9), (10 ), and (11) may require
slight up and down movement to free shaft (4) during
removal.
5.
Remove shaft (4) from right end of plate (12).
6.
Using Allen wrench, remove two 10-32 x 5/8 screws (13) that were installed in Frame 2.
7.
Using 3/8" flat tip screwdriver, remove two plugs (8), two plungers (9), two springs
( 10), and two plungers (11).
GO TO FRAME 4
Para 4-19 Cont
Vol II
4-26
