ARMY TM 9-1240-379-34
MARINE CORPS TM 04332A-34
3-3. DAYLIGHT BODY ASSEMBLYMAINTENANCE INSTRUCTIONS (cont)
INSPECTION/REPAIR
Replace any damaged, missing, or broken
p a r t s . See TM 9-1240-379-34P.
REASSEMBLY
1 Fabricate replacement electrical wire (fig.
C-1, app C).
2 Install electrical wire (1) through contact
opening. Feed electrical wire (1) through
daylight body assembly housing by gent-
ly pushing a probe through wire passage
hole (2).
3 Pull loose end of electrical wire (1) from
opening for incandescent lamp receptacle
far enough to permit making solder
connection.
NOTE
When installing connector,
make sure notch on connector
is correctly positioned in
groove to allow proper
grounding.
4 Using solder, install electrical ring (3) on
connector (4).
5 Using solder, attach electrical wire to op-
posite contact prong and install connec-
tor (4) in daylight body assembly (5).
9 Coil excess electrical wire to allow con-
6 Using tubular spanner wrench, install ex-
tact to be installed in daylight body
ternally threaded ring (6).
assembly (5); secure contact with
setscrew (11) and apply sealing com-
7 Install incandescent lamp (7), gasket (8),
pound to setscrew hole and wire passage
and Iampholder (9) in daylight body
hole (2).
assembly (5).
10 After maintenance has been completed,
8 Using solder, attach end of electrical wire
purge and charge in accordance with TM
750-116.
(1) to contact (10).
