TM 9-1240-382-34
2-5 DAYLIGHT BODY ASSEMBLY - CONTINUED
LOCATION
ITEM
REMARKS
ACTION
INSTALLATION
Secure block (1) to body
assembly (2) using two
Rear Alinement
lockwashers (3) and screws
Body
Key and Block
(4). Install alinement key (5)
Assembly
on body assembly (2) with
Block (1)
screws (6). Install spring (7).
Body Assembly (2)
Insert plunger (8) halfway into
Lockwasher (3)
key (5) and install snap ring
Screw (4)
(9) on plunger (8). Depress
Key (5)
plunger and slide snap ring
Screw (6)
into groove on plunger.
Spring (7)
Plunger (8)
Remove
screws
(1),
Snap Ring (9)
lockwasher (2) and remove
REMOVAL
the cover (3) with pad (4)
attached. from body assembly
Rubber
(6). Remove the gasket (5).
Body
Pad
Assembly
Clean
the
screws
and
washers with solvent P-D-680
Screw (1)
Lockwasher (2)
Wipe the cover clean with a
Cover (3)
lint-free cloth.
Pad (4)
Gasket (5)
Inspect the bonded rubber
Body Assembly (6)
pad for deterioration, chipped,
torn or unbonded condition. If
CLEANING
the rubber pad requires
replacement, remove the pad
CAUTION
Rubber
and clean all traces of the old
Do not clean the cover with
Body
Pad
bonding compound from the
solvent when the bonded rubber
Assembly
cover. Use adhesive MIL-A-
pad is attached.
5092, Type 11, (App B) and
bond a new pad to the cover.
Repair
is
limited
to
INSPECTION/REPAIR
replacement
of
missing,
defective, or damaged parts.
Rubber
Body
Pad
NOTE
Assembly
Ensure that the cover is clean, free
of grease and dry before bonding a
new pad to cover.
2-24
