TM 9-1240-380-34
Section 5. SWITCH ASSEMBLY
SWITCH ASSEMBLY MAINTENANCE PROCEDURES INDEX
Task
Reference (para)
Removal
Installation
SWITCH ASSEMBLY REMOVAL
APPLICABLE CONFIGURATIONS: M36E1
TOOLS: # 1 cross tip screwdriver ( Phillips type)
Soldering iron
Long round nose pliers
PERSONNEL: One
REFERENCES: JPG 41C for: Tagging wires
Unsoldering wires
EQUIPMENT CONDITION: Elbow assembly on work bench, power off
PRELIMINARY PROCEDURES: Remove regulator assembly ( para 7-10 )
FRAME 1
step
Procedure
1.
Using screwdriver, remove screw ( 1), clamp (2) and terminal (3) and terminal (4).
Reinstall terminal (3), clamp (2) and screw (1).
2.
Using screwdriver, remove four screws (5) and four lockwashers (6).
3.
Pull out switch assembly (7) far enough to work without straining wires.
4.
Slide sleevings (8) back onto wires to expose terminals.
5.
resistor (9). Tag and unsolder wires from terminals of TUBE resistor ( 10) (JPG).
Remove switch assembly.
6.
Remove gasket (11 ).
END OF TASK
Vol II
