TM 9-1240-380-34
Section 4. REGULATOR ASSEMBLY
REGULATOR ASSEMBLY MAINTENANCE PROCEDURES INDEX
Task
Reference (para)
Removal
Installation
REGULATOR ASSEMBLY REMOVAL
APPLICABLE CONFIGURATIONS: M36E1
TOOLS: #1 cross tip screwdriver ( Phillips type)
PERSONNEL: One
EQUIPMENT CONDITION: Elbow assembly on work bench, power off
FRAME 1
Step
Procedure
Using screwdriver, remove four screws (1) from regulator assembly (2).
Pull out regulator assembly (2) far enough to reach connector (3) connected to a
connector on the horizontal circuit board (4).
Disconnect connector (3) and remove regulator assembly (2).
Remove gasket (5).
END OF TASK
Vol II