TM 9-1240-380-34
REGULATOR ASSEMBLY INSTALLATION
APPLICABLE CONFIGURATIONS: M36E 1
TOOLS: #1 cross tip screwdriver (Phillips type)
PERSONNEL: One
EQUIPMENT CONDITION: Elbow assembly on work bench, power off
Procedure
Put gasket (1) around inside rim of regulator assembly cover plate (2).
Through gasket (1), connect connector (3) to P1 (4) on the horizontal circuit board (5)
of the regulator assembly (6).
Put regulator assembly (6) on locator pin (7). Line up holes with gasket (1) and elbow
assembly housing (8). Using screwdriver, install four screws (9).
NOTE
FOLLOW-ON MAINTENANCE:
END OF TASK
Vol II