TM 9-1240-380-34
Section 6. CAP ASSEMBLY, CONVERTER, AND POWER SUPPLY
PROCEDURES INDEX
Reference (para)
Task
Removal and Disassembly
Assembly and Installation
CAP ASSEMBLY, CONVERTER, AND POWER SUPPLY REMOVAL AND
DISASSEMBLY
APPLICABLE CONFIGURATIONS: M36
TOOLS: Soldering iron
1-5/8 " tubular spanner wrench
1/1 6 "socket head screw key (Allen wrench or equivalent)
P E R S O N N E L: O n e
REFERENCES: JPG 41C for unsoldering wires
EQUIPMENT CONDITION: Infrared body assembly on work bench, power off
PRELIMINARY PROCEDURES: Remove rotary switch (para 6-22, steps 2, 3 and caution)
Procedure
Using your hand, turn cap assembly (1) counterclockwise and remove gasket (2).
NOTE
Either battery or converter may be installed. Both are
removed in the same way.
Remove battery or converter (3) from sleeve assembly (4).
Push in and turn sleeve assembly (4) counterclockwise and remove from housing.
Turn sleeve (5) slightly clockwise and remove from power supply (6). Remove spring
tension washer (7).
Using spanner wrench, remove externally threaded ring (8).
Using Allen wrench, remove two setscrews (9).
6-22) (JPG).
Remove insulator (11).
END OF TASK
Vol II
