TM 9-1240-216-34
4-33.
RESISTOR ASSEMBLY INSTALLATION (CONT)
FRAME 2
Step
Procedure
Place red wire (1) of resistor (2) on terminal (3) of terminal board (4).
1.
Using screwdriver, put on lockwasher (5) and screw (6).
2.
3.
Position white wire (7) of resistor (2) on terminal (8) of terminal board (4).
4.
Using screwdriver, put on lockwasher (9) and screw (10).
Using slip joint pliers, install bushing (11) into body assembly (12).
5.
Using Allen wrench, tighten setscrew (13) to fasten bushing.
6.
7.
Put preformed packing (O-ring) (14) on nut (15).
Using open end wrench, put nut (15) on bushing (11).
8.
9.
Put washer (16) on bushing (11) and install cap (17).
Using screwdriver, fasten chain of cap (17) to body assembly (12) with lockwasher (18)
10.
and screw (19).
11.
Using open end wrench, remove two setscrews (20) from body assembly (12).
Using sealing gun, force sealing compound into holes (21).
12.
Using Allen wrench, install two setscrews (20) into two holes (21) in body assembly
13.
(12).
NOTE
FOLLOW-ON MAINTENANCE
Install electron tube (para 4-30, frame 2).
Install cable (para 4-21).
Install cover (para 4-15).
Do checkout procedure (Vol I, para 2-2).
END OF TASK
Para 4-33 Cont
4-64
Vol II
