TM 9-1240-216-34
BODY ASSEMBLY INSPECTION UPON RECEIPT (CONT)
3-2.
NOTE
For M24 old and new configurations, do steps 3 and 4
only.
FRAME
2
Reference
Maintenance Action
Procedure
Step
...
Tell your supervisor.
Check two eyepieces (1) for
1.
cracks or scratches. Look in
eyepieces and check for dirt or
moisture inside.
...
If missing or cannot be read,
Check that identification plate
2.
tell your supervisor.
(2) can be read.
...
Tighten. If damaged or
Using 1/4" screwdriver, check
3.
missing, send body assembly
that two studs (3) are tight.
to depot for repair.
Tighten. If damaged or
...
Using 1/16" pin open face
4.
missing, send body assembly
spanner wrench, check that
to depot for repair.
plug (4) is tight.
...
Tighten. Replace if damaged
Using 3/16" screwdriver,
5.
or missing.
check that two identification
plate screws (5) are tight.
GO TO FRAME 3
Para 3-2 Cont
3-3
Vol II