TM 9-1240-216-34
3-2.
BODY ASSEMBLY INSPECTION UPON RECEIPT (CONT)
FRAME 6
Step
Procedure
Maintenance Action
Reference
1.
Check short stud (1) on
Replace if damaged or missing.
plate assembly (2) for one washer
(3) between segment (4) and lock
nut (5).
2.
Using open-end wrench, check
Tighten. Replace if missing
that lock nut (6) is tight.
or damaged.
3.
Clean and lubricate. Repair
Move segment (4) through its
or replace if it binds.
full travel and check for
binding.
NOTE
Do steps 4 and 5 for M24 configurations only.
4.
L i n e up notch in segment (4)
w i t h screw (7) holding plate
a s s e m b l y (2) to support (8)
o n body assembly (9),
Tighten locking lever (10).
Tighten. Replace if
5.
Using 3/16" screwdriver,
missing.
check that screw (7) in plate
assembly (2) under segment (4) is
tight.
GO TO FRAME 7
Para 3-2 Cont
3-8
Vol II