TM 9-1240-216-34
CHAPTER 3
INSPECTION UPON RECEIPT
SCOPE
3-1.
This chapter gives procedures to check the M19 and M24 periscopes for faults you can see when they are
received in the DS/GS shop. It also tells you what part of this volume to go to for various repairs. A
complete inspection should be made and all faults listed on DA Form 2404 before taking any
maintenance actions.
BODY ASSEMBLY INSPECTION UPON RECEIPT
3-2.
TOOLS: 7/16" open end wrench
3/16" flat tip screwdriver
1/4" flat tip screwdriver
1/16" pin open face spanner wrench
1/16" socket head screw key (Allen wrench
or equivalent)
#2 Phillips
SUPPLIES:
PERSONNEL: One
Cleaning and lubricating
REFERENCES: JPG 4lC for:
Completing DA Form 2404
TM
43-0139 for painting
TM
9-254 for general maintenance
TM
10 for removing head assembly (TM 9-2350-215-10 for M60A1,
TM
9-2350-257-10 for M60A1 Rise, TM 9-2350-260-10 for M60, and
TM
9-2350-222-10 for M728)
EQUIPMENT CONDTION: Body assembly on work bench; power disconnected
PRELIMINARY PROCEDURES: Remove head assembly (TM 10)
Handle lenses with care. Do not put fingerprints on them.
Do not place on rough surfaces. Clean after inspection.
NOTE
One body assembly configuration will be pictured for use
with inspection procedure.
Para 3-1
3-1
Vol II