TM 9-1240-380-34
PLUNGER, STRIKE AND KEY INSTALLATION
APPLICABLE CONFIGURATIONS: M36E1
TOOLS: Scriber
Tweezers
#1 cross tip screwdriver ( Phillips type)
P E R S O N N E L : One
EQUIPMENT CONDITION: Elbow assembly, plunger, strike and key and associated parts on work
bench
FRAME 1
Procedure
Step
While holding strike (1) in slot of key (2), use screwdriver to install screw (3).
1.
While holding strike (1) and key (2) on elbow assembly (4), use screwdriver to install
2.
two screws (5).
Using your fingers, install spring (6) into key (2).
3.
Push plunger (7) part way through hole in key (2), groove up.
4.
Using tweezers, place retaining ring (8) over plunger (7).
5.
6.
Using scriber, press on plunger (7) and slide retaining ring (8) until it fits into groove of
plunger (7).
NOTE
FOLLOW-ON MAINTENANCE:
Do checkout procedure ( Vol I, para 2-5).
END OF TASK
Vol II
