TM 9-1240-380-34
Section 2. PLUNGER, STRIKE AND KEY
PLUNGER, STRIKE AND KEY MAINTENANCE PROCEDURES INDEX
Reference (para)
Task
Removal
Installation
PLUNGER, STRIKE AND KEY REMOVAL
APPLICABLE CONFIGURATIONS: M36E1
TOOLS: Scriber
Tweezers
# 1 cross tip screwdriver ( Phillips type)
PERSONNEL: One
EQUIPMENT CONDITION: Elbow assembly on work bench
FRAME 1
Step
Procedure
Plunger (1) is spring loaded. Use care when removing
retaining ring (2).
1.
Using scriber, press in and hold plunger (1). Using tweezers, remove retaining ring (2)
from groove in plunger (1). Spring (3) will push plunger (1) part way through hole in
key (4).
While holding retaining ring (2) with tweezers, use fingers to pull plunger (1) from key
2.
(4).
3.
Remove spring (3).
4.
Using screwdriver, remove two screws (5), key (4).
5.
Using screwdriver, remove screw (6) from key (4) and strike (7).
END OF TASK
Vol II
