TM 9-1240-380-34
INFRARED BODY ASSEMBLY INSPECTION UPON RECEIPT (CONT)
3-5.
FRAME 3
Reference
Maintenance Action
Procedure
Step
Tighten. Replace gasket if
1.
Check that cap (1) is tight.
missing.
Check that gasket (2) is
installed.
Tighten. Replace if missing.
...
Using 1/4" screwdriver, check
2.
that four screws (3) are tight.
If plate cannot be read, tell
...
Check switch plate (4) can be
3.
your supervisor.
read.
Tighten. Replace if missing.
4.
Using 3/8" open end wrench,
check that valve cap (5) is
tight.
Tighten. Replace if missing.
...
5.
Using 1/16" pin open face
spanner wrench, check that
two screws (6) are tight.
...
Tighten. Replace if missing.
6.
Using 1/4"' screwdriver, check
that eight screws (7) on two
knob assemblies (8) are tight.
GO TO FRAME 4
3-26
Vol II