TM 9-1240-285-34&P
T E L E S C O P E MOUNT INSTALLATION
TOOLS: Soft face hammer
3/4" socket
3/8'" square drive ratchet
5/ 16" open end wrench
PERSONNEL: Two
EQUIPMENT CONDITION: Telescope mount ready to be mounted in tank
Procedure
Step
NOTE
Do the next step only if locating pins have been
removed from recoil mechanism housing in the vehicle.
(Repairman A) Using soft face hammer, drive two locating pins (1) into holes on recoil
1.
mechanism housing.
Two repairmen are needed to install telescope mount
(2). If telescope mount (2) falls, equipment damage and
injury to personnel may result.
(Repairman A and B) Place telescope mount (2) on recoil mechanism housing so that
2.
locating pin holes (3) are lined up with locating pins (1).
Hold telescope mount (2).
3.
(Repairman A)
4.
(Repairman B) Using socket and ratchet, install five flat washers (4), five lockwashers
(5) and five screws (6).
GO TO FRAME 2
4-8
Vol II
