TM 9-1240-285-34&P
4-5.
TELESCOPE MOUNT REMOVAL (CONT)
FRAME 2
Step
Procedure
1.
(Repairman B) Using two mounting screws (1) from telescope mount (2) as jackscrews,
insert mounting screws (1) into jackscrew holes (3).
(Repairman A) Hold telescope mount (2).
2.
NOTE
Telescope mount (2) will move toward you and off of
locator pins (4) as mounting screws (1) are tightened.
(Repairman B) Using socket and square drive ratchet, tighten mounting screws (1) until
3.
telescope mount (2) is clear of locating pins (4).
4.
(Repairman A) Remove telescope mount (2).
5.
(Repairman B) Using socket and square drive ratchet, remove two mounting screws (1).
NOTE
Remove locating pins (4) only if they need to be
replaced.
6.
(Repairman B) Using slip joint pliers, remove two locating pins (4) from recoil
mechanism housing in vehicle.
END OF TASK
4-6
Vol II