TM 9-1240-216-34
4-11.
ELEVATION LOCK ASSEMBLY ASSEMBLY (CONT)
FRAME 2
Step
Procedure
Place slot of segment (1) over bearing (2) on plate assembly (3).
1.
Place special washer (4) on short stud (5) of plate assembly (3). Slide small notch in
2.
washer (4) into groove in stud (5).
Using open end wrench, put nut (6) into short stud (5) of plate assembly (3).
3.
Place key washer (7) on long stud (8) of plate assembly (3).
4.
Line up splines of round nut (9) with splines in lever (10).
5.
Using soft face hammer, drive round nut (9) into lever (10).
6.
Screw lever (10) onto long stud (8) of plate assembly (3).
7.
Place key washer (11) on long stud (8).
8.
Place washer (12) in groove in long stud (8).
9.
Using open end wrench, put nut (13) into long stud (8) of plate assembly (3).
10.
END OF TASK
Para 4-11 Cont
4-17
Vol II