TM 9-1240-380-34
PLATE ASSEMBLY ASSEMBLY
TOOLS: #0 cross tip screwdriver ( Phillips type)
--
4 oz ball peen hammer
-
1/8" punch
5/8" open end wrench
PERSONNEL: One
EQUIPMENT CONDITION: Plate assembly parts on work bench
FRAME 1
Step
Procedure
1.
Put two studs (1) through two holes (2) in plate assembly (3).
Line up the holes in the rim of the studs (1) with the holes in the back of the plate
2.
assembly (3). Using screwdriver, install six washers (4) and six screws (5).
3.
Using hands, screw two wing nuts (6) on to the two studs (1).
4.
Using wrench, screw two nuts (7) on the two studs (1). Line up the holes in the nuts
(7) with the holes in the studs (1).
Using punch and hammer, install two pins (8) through nuts (7) and studs (1).
5.
END OF TASK
Vol II