TM 9-1240-400-34&P
11
Apply sealant adhesive (item 5, appx C) to lens cap (20), electrical lead (21), and threads of ring (22).
12
Pull wire with lamp base through to the front of the electronic component (23).
13
Install lens cap (20), electrical lead (21), and electronic component (23).
14
Install identification plates (24 and 25) and loosely secure with four new lockwashers (26) and four screws (27).
15
Using tubular spanner wrench, install ring (22) in cover (3).
16
Insert lamp base portion of electronic component (23) into electrical lead (21). Position wire in recessed area to
accommodate protective dust cap (28).
17
Cut and strip contact wire to correct length. Using solder (item 12, appx C), and soldering flux (item 6, appx C),
solder contact wire to electrical contact (15).
18
Install and secure protective dust cap (28) with two screws (29).
19
Apply sealant adhesive (item 5, appx C) to outer edge of protective dust cap (28).
20
Tighten four screws (27).
21
Purge in accordance with TM 750-116.
5-23
