TM 9-1240-382-34
2-4 ELBOW ASSEMBLY - CONTINUED
LOCATION
ITEM
REMARKS
ACTION
REASSEMBLY
Elbow
Switch
Assembly
Assembly
solder resistor (1, R4) to Variable
Resistor (2).
Insert Variable
Resistor (2, R2) through the
Resistor (1)
upper hold in cover plate (3).
Variable Resistor (2)
Install lockwasher (4) and nut (5).
Cover Plate (3)
Install knob (6) and secure by
tightening setscrews (7). Using
one end of resistor (8, R1) to
terminal (9) of ground wire (10).
Position terminal (9) on the shaft
Lockwasher (4)
of variable resistor (11, R3).
Nut (5)
Insert variable resistor (11, R3)
Knob (6)
through the lower hole in cover
Setscrew (7)
plate (3) and install lockwasher
Resistor (8)
(12), and nut (13). Install knob
Terminal (9)
(14) and secure by tightening
Ground Wire (10)
setscrews (15).
Position the
Variable
terminal (16) against the cover
Resistor (11)
plate (3) and secure with screw
Lockwasher (12)
(17).
Nut (13)
Knob (14)
Setscrew (15)
Terminal (16)
solder the loose end of resistor
Screw (17)
(8, R1) to variable resistor (11,
R3). Using new wire, solder a
jumper between variable resistor
(2, R2) and the terminal.
NOTE
Refer to the electrical
information.
Resistor (R1)
Variable
Resistor (R2)
Variable
Resistor (R3)
Resistor (R4)
2-14