TM 9-1240-271-34&P
SUPPORT INSTALLATION
TOOLS: #2 cross tip screwdriver offset (Phillips type)
7/32" socket head screw key (Allen wrench or equivalent)
1/4" flat tip screwdriver offset
4 oz. ball peen hammer
1/2" socket wrench (3/8" drive)
PERSONNEL: One
EQUIPMENT CONDITION: Mount in tank
I
FRAME 1
Procedure
Slide support (1) upwards over bottom of mount (2) until mounting holes (3) are lined
1.
up.
2.
Install four screws (4), four washers (5), and four nuts (6) loosely.
3.
Using hammer, tap two keys (7) through support (1) and into mount (2).
4.
Using flat tip offset screwdriver, install four screws (8).
Using socket wrench and cross tip screwdriver, tighten four nuts (6).
5.
Install shield operating handle assembly (9) onto bracket (10).
6.
7.
Using Allen wrench, install two screws (11) and two washers (12).
NOTE
FOLLOW-ON MAINTENANCE
Do performance test (Vol I, para 2-2).
END OF TASK
Vol II
