TM 9-1240-216-34
B-2.
ASSEMBLY (CONT)
FRAME 2
Procedure
Step
1.
Connect (-) black lead alligator clip (1) to any bare place on high voltage power supply
(2).
2.
Connect (+) red lead alligator clip (3) to center pin (4) of high voltage power supply
input connector (5) without touching body (6).
Turn on 0-36 VDC power supply.
3.
In the next step, if the current starts to go over 1
ampere, immediately set the voltage to zero. Turn off
0-36 VDC power supply and tell your supervisor.
While watching both the voltmeter (7) and current meter (8), slowly raise voltage to
4.
24V.
END OF TASK
Para B-2 Cont
B-3/(B-4 blank)
Vol I