TM 9-1240-216-34
APPENDIX B
ASSEMBLY OF POWER SUPPLIES
B-1.
SCOPE
This appendix tells how to connect the 0-36 VDC power supply and the high voltage power supply to the
M 19 or M24 series periscopes.
ASSEMBLY
B-2.
TEST EQUIPMENT: High voltage power supply (16,000 VDC) (taken from
tank)
0-36 VDC power supply
Multimeter test leads
High voltage cable
WARNING
The high voltage power supply puts out 16,000 VDC as
soon as input power is applied. There is no on/off switch.
NOTE
Do not connect 24V input power to the high voltage power supply until after its output is
connected to the periscope.
The high voltage cable is used to connect the high voltage power supply output to the
periscope. Both cable end connectors are identical, so either end of the cable may go to either
connector.
The high voltage power supply connectors are not labeled, but are different sizes. The high
voltage connector will fit only the connector providing the high voltage output.
Para B-1
B-1
Vol I
