TM 9-1240-380-34
LATCH INSTALLATION
TOOLS: Long nose pliers
# 1 cross tip screwdriver (Phillips type)
PERSONNEL: One
EQUIPMENT CONDITION: Body assembly on work bench
FRAME 1
Procedure
Step
NOTE
Cotter pin (1) is not used with latch (2). Begin at step 3
when installing latch (2).
1.
Open latch (3) as shown in picture and put in cotter pin (1).
2.
Using pliers, bend ends of cotter pin (1) to prevent cotter pin (1) from coming out of
latch (3).
3.
While holding latch (2) or (3) in place, use screwdriver to install two screws (4) and
two washers (5) in body assembly (6).
END OF TASK
.
Vol II