TM 9-1240-408-13&P
0008 00
2.
Route the adapter end of the connector adapter wire out of the battery
compartment through any convenient hole. Tape the wire and any
sharp edges of the hole to prevent damage and possible shorting of the
wire.
3.
Run the connector adapter wire from the battery compartment to the
left of the foot well, forward along the foot well, then up to the
mounting plate. Secure adapter connector wire in place with tape,
nylon cable ties, or similar materials.
4.
Coil excess wire near adapter and secure with tape, nylon cable ties, or
similar materials. Ensure an adequate length of wire is left to allow for
free range of motion with binocular.
5.
Attach the special purpose cable assembly to the connector on the
Objective Lens and Battery Compartment End Plate.
6.
Connect the special purpose cable assembly of the M25 Stabilized
Binocular to the connector adapter.
0008 00-5