TM 9-1240-401-34&P
42 Remove three machine screws (76) and three lock-
washers (77) to free three clamps (78) from eleva-
tion bracket (79). Discard Iockwashers.
43 Remove cable assembly (80) by removing two cap
screws (81 ) and two Iockwashers (82). Discard
Iockwashers
44 Remove spring clip (83) from bracket(11 ) by re-
moving machine screw (84).
b. Repair
I
1 Remove corrosion, grease, and dirt from all parts.
Refer to TM 9-254 for cleaning instructions.
2 Visually inspect for missing or damaged parts.
3 Repair or replace parts in accordance with author-
ized parts listed in appendix D.
c. Assembly
I
1
Apply grease (item 6, appx B) to bearing surfaces
of bracket (11 ) and yoke (10).
2
Position yoke (10) on bracket (11).
3
Install yoke pin (9) in bracket (11) and yoke (10)
and secure with three new Iockwashers (8) and
three cap screws (7).
4
Install spring (5) and headed grooved pin (4) in
yoke pin (6) and secure with retaining ring (3).
5
Install retaining ring (3), headed grooved pin (4),
spring (5), and yoke pin (6) as a unit in yoke (10)
and bracket (11). Secure with three new lock-
washers (2) and three cap screws (1).
2-11
