TM 9-1240-380-34
BODY ASSEMBLY INSPECTION UPON RECEIPT (CONT)
3-4.
FRAME 6
Reference
Step
Procedure
Maintenance Action
1.
Tighten. Replace if missing.
Using #2 Phillips screwdriver,
...
check that screw (1) is tight.
Tighten. Replace if missing.
...
2.
Using #2 Phillips screwdriver,
check that three screws (2)
are tight and clamp is not
missing.
JPG 41C
Replace housing assembly if
Check wire terminals (3) for
3.
damaged. Clean if corroded.
damage or corrosion.
...
Tighten. Replace if missing.
4.
Using #1 Phillips and #1
offset Phillips screwdrivers,
check two screws (4) for
tightness.
Replace housing assembly if
5.
Check boot (5) for damage.
damaged.
6.
Check two contact pins (6)
JPG 41C
Clean if corroded. Replace
housing assembly if damaged.
for damage or corrosion.
7.
If springs are weak or
Check both contact pins (6)
missing, replace housing
return to start position by
assembly.
pushing pins in with fingers.
NOTE
FOLLOW-ON MAINTENANCE:
Correct faults listed on DA
Form 2404 that may affect
the checkout procedure.
Do checkout procedure
END OF TASK
Vol II
3-20