TM 9-1240-380-34
HEAD ASSEMBLY INSPECTION UPON RECEIPT (CONT)
3-3.
FRAME 3
Reference
Maintenance Action
Procedure
Step
Tighten. Replace if missing.
Using #2 Phillips screwdriver,
1.
check that 13 screws (1) are
tight.
2.
Replace cap, valve stem, and
Using 3/8" wrench, remove
core if missing or damaged.
cap (2). Using valve core
wrench, check that valve core
Tighten valve stem if loose.
(3) is tight and seated. Using
7/ 16" wrench, check that stem
(4) is tight.
Using 3 / 8" wrench, install cap
3.
(2).
Check that strap (5) is not
Replace if damaged or
4.
missing.
damaged.
If bent or missing, tell your
...
Check that pin (6) is not bent
5.
supervisor.
or missing.
Replace if missing.
Check that pin (7) is not
6.
missing.
...
7.
If wire seal (8) is broken or
Check that wire seal (8) is
not broken or missing.
missing, tell your supervisor.
Using 3/16" flat tip
8.
If screw is loose or
...
screwdriver, check that screw
missing, tell your supervisor.
(9) is tight.
GO TO FRAME 4
Para 3-3 Cont
Vol II
3-6
