TM9-1240-350-35P
Section I. INTRODUCTION
Code
Explanation
1. Scope.
dictates that a minimum quantity be
This manual lists repair parts, special tools, and
available in the supply system.
equipment required for the performance of direct
P9
Assigned to items which are NSA design
support, general support, and depot maintenance of the
controlled; unique repair parts, special
telescope mount M90.
tools, test, measuring and diagnostic
equipment, which are stocked and supplied
2. General.
by the Army COMSEC logistic system, and
This Repair Parts and 'Special Tools List is divided
which are not subject to the provisions of
into the following sections:
AR 380-41.
a. Repair Parts-Section II. A list of repair parts for
P10
Assigned to items which are NSA design
the performance of maintenance at the direct support,
controlled: special tools, test measuring and
general support, and depot level in figure and item
diagnostic
equipment
for
COMSEC
number sequence.
support, which are accountable under the
b. Special Tools, Test and Support Equipment-
provision of AR 380-41, which are stocked
Section III. A list of special tools, test and support
and supplied by the Army COMSEC logistic
equipment for the performance of maintenance at the
system.
direct support, general support, and depot level.
M
Repair parts which are not procured or stocked,
c. Federal Stock Number and Reference Number
but are to be manufactured in indicated
Index-Section IV. A list of Federal Stock Numbers in
levels.
ascending numerical sequence followed by a list of
A
Assemblies which are not procured or stocked
reference numbers in ascending alpha-numeric
as such, but are made up of two or more
sequence, cross-referenced to the illustration figure
units.
Such component units carry
number and item number.
individual stock numbers and descriptions,
are procured and stocked separately and
3. Explanation of Columns.
can be assembled to form the required
The following provides an explanation of columns in
assembly
at
indicated
maintenance
the tabular lists in Sections II and III.
categories.
a. Source, Maintenance and Recoverability Codes
X
Parts and assemblies which are not procured or
(SMR), Column 1:
stocked and the mortality of which normally
(1) Source code, indicates the selection status
is below that of the applicable end item or
and source for the listed item. Source codes are:
component. The failure of such part or
Code
Explanation
assembly should result in retirement of the
P
Repair parts, special tools, and test equipment
end item from the supply system.
which are stocked in or supplied from the
X1
Repair parts which are not procured or stocked.
GSA/DSA, or Army supply system and
The requirements for such items will be
authorized for use at indicated maintenance
filled by use of the next higher assembly or
categories.
component.
P-2
Repair parts, special tools and test equipment
X2
Repair parts which are not stocked.
The
which are procured and stocked for
indicated maintenance category requiring
insurance purposes because the combat or
such repair parts will attempt to obtain
military essentially of the end item
same through cannibalization.
GPO 825-215-1
2
