Section I. INTRODUCTION
Code
Explanation
1. Scope.
stocked and supplied by the Army COMSEC
This manual lists repair parts, special tools, and
Logistic System and which arc not subject to the
provisions of AR 380--11.
support equipment required for the performance
P10
Assigned to items which are NSA design con-
of direct support, general support, and depot
trolled: special tools, test, measuring and diag-
maintenance of the articulated telescope M127
nostic equipment for COMSEC support which are
and M119.
accountability under the provisions of AR X80-41,
and which are stocked and supplied by the Army
COMSEC Logistic System.
2. General
M
Repair parts, special tools and test equipment
This Repair Parts and Special Tools List is
which are not procured or stocked as such in
the supply system hut are to be manufactured
divided into the following sections:
at indicated maintenance levels.
A
Assemblies which are not procured or stocked as
pair parts authorized at the direct support, gen-
such but are made up of two or more units. Such
component units carry individual stock numbers
eral support, and depot levels for the performance
and descriptions, are procured and stocked sep-
of maintenance. This list also includes parts
arately, and can be assembled to form the re-
which must be removed for the replacement of
quired :~ssonhly at indicated maintenance cate-
the authorized parts. Parts lists are composed of
gories.
functional groups in ascending numerical se-
X
Parts and assemblies that are not procured or
quence, with parts in each group listed in figure
stocked because the failure rate is normally be-
low that of the applicable end item or compon-
and item number sequence.
ent. The failure, of such part or assembly should
b. Special Tools List-Section III. A list of
result in retirement of the end item from the
supply system.
special tools, test and support equipment auth-
X1
Repair parts which are not procured or stocked.
orized for the performance of maintenance at the
The requirement for such items will be filled by
direct support, general support, and depot levels.
the next higher assembly or component.
X2
Repair parts, special tools and test equipment
c. Federal Stock Number and Reference Num-
which are not stocked and have no foreseen mor-
tality. The indicated maintenance category re-
merical sequence, of all Federal stock numbers
quiring such repair parts will attempt to obtain
appearing in the listings followed by a list, in
the parts through cannibalization or salvage. The
alphameric sequence, of all reference numbers
item may be requisitioned, with exception data,
appearing in the listings. Federal stock number
from the end item manager for immediate use.
G
Major assemblies that are procured with PEMA
and reference numbers are cross-referenced to
funds for initial issue only as exchange assem-
each illustration figure and item number appear-
blies at DS and GS level. These assemblies will
ance.
not be stocked above DS and GS level or returned
to depot supply level.
3. Explanation of Columns.
Note: Cannibalization or salvage may be used as a
source of supply for any items source coded above ex-
The following provides an explanation of col-
cept those coded X1 and aircraft support items as re-
umns found in the tabular listings.
stricted by AR 700-42.
(2) Maintenance Code. Indicates the lowest
a. Source, maintenance, and Recoverability
category of maintenance authorized to install the
Codes (SMR).
repair parts and/or use the special tool or test
(1) Source Code. Indicates the source for
equipment for each application. Capabilities of
the listed items. Source codes are:
higher maintenance categories are considered
Code
Explanation
equal or better. Maintenance codes are:
P
Repair parts, special tools, and test equipment
Code
supplied from the GSA/DSA, or Army supply
Explanation
C
Crew/operator
system, and authorized for use at indicated main-
O
Organizational maintenance
tenance categories.
F
Direct support maintenance
P2
Repair parts, special tools, and test equipment
General support maintenance
H
which are procured and stocked for insurance
D
Depot maintenance
purposes because the combat or military essen-
tiality of the end item dictates that a minimum
(3) Recoverability Code. Indicates whether
quantity be available in the supply system.
unserviceable items should be returned for re-
P9
Assigned to items which are NSA design con-
covery or salvage. Items not coded are nonrecov-
trolled: unique repair parts, special tools, test,
erable. Recoverability codes are:
measuring and diagnostic equipment, which are
1
