TM 9-1240-285-34&P
INTRODUCTION
Section 1. GENERAL
1-1.
SCOPE
This volume contains the maintenance requirements and procedures for direct support and general
support (DS/GS) maintenance for the M114 Telescope Mount. See Volume I for troubleshooting
procedures.
1-2.
ORGANIZATION
a. Chapter 2, General Maintenance Information, lists the maintenance items and references other
procedures that are necessary to do the maintenance in this manual.
b. Chapter 3, Inspection Upon Receipt, gives the kind of defects to look for when the telescope
mount is returned to DS/GS. A complete inspection should be made and faults listed on DA Form 2404
before any repairs are made.
c. Chapter 4, Maintenance Procedures, give step-by-step procedures to repair faults found during
inspection or troubleshooting.
d. Chapter 5, Final Inspection, gives procedures to be done after repair to make sure that the
telescope mount works.
e. Chapter 6, Packaging, gives procedures for packaging the telescope mount for storage or
shipment.
f. Appendix A, Expendable Supplies and Materials, lists the supplies and materials needed to repair
the telescope mount.
g. Appendix B, Maintenance Task Index, helps you find the necessary maintenance tasks for the
telescope mount.
h. Appendix C, Fabricated Tool, gives you information to make the spring wrench necessary to do
the maintenance procedures.
i. Appendix D, Repair Parts and Special Tools List, gives a listing of repair parts, special tools, and
support equipment required for the performance of direct support, general support, and depot main-
tenance of the telescope mount.
Vol II
1-1
