TM 9-6650-213-35P
Section I. INTRODUCTION
Explanation
Code
1. Scope
P10
Assigned to items which are NSA design
This manual lists repair parts, special tools,
controlled: special tools, test, measur-
and equipment required for the performance of
ing and diagnostic equipment for
direct support,general support, and depot main-
COMSEC support, which are account-
tenance of the Periscope, M17.
able under the provision of AR 380-41,
which are stocked and supplied by the
2. General
Army COMSEC logistic system.
M
Repair parts which are not procured or
This Repair Parts and Special Tools List is
stocked, but are to be manufactured
divided into the following sections:
in indicated levels.
a. Repair Parts-Section II. A list of repair
A
Assemblies which are not procured or
parts for the performance of maintenance at the
stocked as such, but are made up of
direct support, general support, and depot level
two or more units. Such component
in figure and item number sequence.
units carry individual stock numbers
and descriptions, are procured and
b. Special Tools, Test and Support Equipment
stocked separately and can be assem-
--Section III. Not applicable.
bled to form the required assembly at
c. Federal Stock Number and Reference Num-
indicated maintenance categories.
ber Index--Section IV. A list of Federal Stock
X
Parts and assemblies which are not pro-
Numbers in ascending numerical sequence fol-
cured or stocked and the mortality of
lowed by a list of reference numbers in ascending
which normally is below that of the
alpha-numeric sequence, cross-referenced to the
applicable end item or component. The
illustration figure number and item number.
failure of such part or assembly should
result in retirement of the end item
3. Explanation of Columns
from the supply system.
The following provides an explanation of col-
X1
Repair parts which are procured or
umns in the tabular list in Section II.
stocked. The requirements for such
items will be filled by use of the next
a. Source Maintenance and Recoverability
higher assembly or component.
Codes (SMR), Column I:
X2
Repair parts which are not stocked. The
(1) Source code, indicates the selection sta-
indicated maintenance category re-
tus and source for the listed item. Source codes
quiring such repair parts will attempt
are:
to obtain same through cannibaliza-
Code
Explanation
tion. Where such repair parts are not
P
Repair parts, special tools, and test equip-
obtainable through cannibalization,
ment which are stocked in or supplied
requirements will be requisitioned,
from the GSA/DSA, or Army supply
with
accompanying
system and authorized for use at in-
through normal supply channels.
dicated maintenance categories.
G
Major assemblies that are procured with
P2
Repair parts, special tools, and test equip-
PEMA funds for initial issue only as
ment which are procured and stocked
exchange assemblies at DSU and GSU
level. These assemblies will not be
combat or military essentiality of the
stocked above DS and GS level or re-
end item dictates that a minimum
turned to depot supply level.
quantity be available in the supply
system.
(2) Maintenance code, indicates the lowest
P9
Assigned to items which are NSA design
category of maintenance authorized to install the
controlled: unique repair parts, spe-
listed item. The maintenance level codes are:
cial tools, test, measure and diagnostic
Explanation
Code
Organizational maintenance
equipment, which are stocked and sup-
O
F
Direct support maintenance
plied by the Army COMSEC logistic
H
General support maintenance
system, and which are not subject to
D
Depot maintenance
the provisions of AR 38041.
2