TM 9-6650-212-34P
Section I. INTRODUCTION
1. Scope.
Code
Explanation
P
This manual lists repair parts, special tools,
Repair Parts, Special Tools, and Test Equipment
supplied from the GSA/DSA, or Army supply
and test equipment required for the performance
system. and authorized for use at indicated main-
of direct support, general support, and depot
tenance categories.
maintenance of the Telescope Observation M49.
Repair Parts, Special Tools, and Test Equipment
P2
2. General.
purposes because the combat or military essen-
tiality of the end item dictates that a minimum
This Repair Parts and Special Tools List is di-
quantity be available in the supply system.
vided into the following sections:
P9
Assigned to items which are NSA design con-
trolled: Unique repair parts, special tools, test,
measuring and diagnostic equipment, which are
stocked and supplied by the Army COMSEC Log-
p a r t s authorized for the performance of main-
istic System and which are not subject to the pre-
t e n a n c e at the direct support, general support,
visions of AR 380-41.
a n d depot level, in figure and item number se-
Assigned to items which are NSA design con-
P10
trolled: Special tools, test, measuring and diag-
quence.
nostic equipment for COMSEC support. which
are accountable under the provisions of AR 380-
b . Special Tools, T e s t a n d S u p p o r t E q u i p -
41, and which are stocked and supplied by the
Army COMSEC Logistic System.
s u p p o r t equipment authorized for the perform-
Repair Parts, Special Tools, and Test Equipment
M
which are not procured or stocked, as such, in the
a n c e of maintenance at the direct support, gen-
supply system but are to be manufactured at in-
eral support, and depot level.
dicated maintenance levels.
Assemblies which are not procured or stocked as
A
c. Federal Stock Number and Reference Num-
such, but are made up of two or more units. Such
component units carry individual stock numbers
and descriptions, are procured and stocked sepa-
N u m b e r s in ascending numerical sequence fol-
rately and can be assembled to form the required
lowed by a list of reference numbers in ascend-
assembly at indicated maintenance categories.
i n g alpha-numeric sequence, cross-referenced to
X
Parts and assemblies that are not procured or
the illustration figure number and item number.
stocked because the failure rate is normally be-
low that of the applicable end item or com-
ponent. The failure of such part or assembly
3. Explanation of Columns.
should result in retirement of the end item from
the supply system.
The following provides an explanation of col-
Repair Parts which are not procured or stocked.
X1
The requirement for such items will be filled by
the higher assembly or component.
X2
Repair Parts, Special Tools, and Test Equipment
a. Source, Maintenance, and Recoverability
which are not stocked and have no foreseen
Codes (SMR), Column 1:
mortality. The indicated maintenance category re
quiring such repair parts will attempt to obtain
(1) Source code, i n d i c a t e s t h e s e l e c t i o n
the parts through cannibalization or salvage, if
s t a t u s and source for the listed item. Source
not obtainable through cannibalization or s
vage, the item may be requisitioned with exc
codes are:
2