3-26. WIRING HARNESS MAINTENANCE INSTRUCTIONS - continued
1 Remove two machine screws (1), two flat washers
(2), and two clamps (3) from housing (4).
2 Remove wiring harness (5).
1 Remove four pieces of insulation sleeving (6) and
unsolder four lug terminals (7) from cable assembly
2 Remove three pieces of insulation sleeving (9)
from cable assembly (8).
3 Using tape, tag and unsolder three wires from re-
ceptacle connector (10).
Remove corrosion, grease, and dirt from all parts.
Refer to TM 9-254 for cleaning instructions.
2 Visually inspect for missing or damaged parts.
3 Repair or replace parts in accordance with author-
ized parts listed in appendix D.