TM 9-1240-380-34
SWITCH ASSEMBLY INSTALLATION
APPLICABLE CONFIGURATIONS: M36E1
TOOLS: #1 cross tip screwdriver ( Phillips type)
Soldering iron
SUPPLIES:
PERSONNEL: One
EQUIPMENT CONDITION: Switch assembly and elbow assembly on work bench
FRAME 1
Procedure
Step
Put gasket (1) on back of switch assembly cover plate (2).
1.
2.
Using screwdriver, remove screw (3), clamp (4) and terminal (5).
3.
Using screwdriver, install terminal (6), terminal (5), clamp (4) (with diode) and screw
(3).
4.
Using soldering iron, solder wires as tagged to reticle resistor (7) and tube resistor (8)
(JPG).
5.
Slide sleevings (9) back onto terminals.
6.
Position switch assembly cover plate (2) on elbow assembly (10) so holes on cover plate
(2) line up.
7.
Using screwdriver, install four lockwashers (11) and four screws (12).
NOTE
FOLLOW-ON MAINTENANCE:
END OF TASK
Vol II