EYEPIECE ASSEMBLY ASSEMBLY
TEST EQUIPMENT: Dioptometer
TOOLS: 0.070" flat tip jewelers screwdriver
REFERENCES: JPG 41C for
Connecting power supply
EQUIPMENT CONDITION: Body assembly on work bench
Check packing (1) for wear or cracks. Clean in warm water with a mild soap. Dry
Put a thin film of grease on surface of packing (1) (JPG).
Using cleaning compound, clean lens of cell assembly (2) (JPG).
Install packing (1) into groove of housing (3).
Install cell assembly (2) into housing (3). Make sure slot in cell (2) is in line with hole
for stop (4) in housing (3).
Using your hand, press stop (4) into eyepiece assembly housing (3).
GO TO FRAME 2