TM 9-1240-380-34
BODY ASSEMBLY INSPECTION UPON RECEIPT (CONT)
3-4.
FRAME 5
Reference
Maintenance Action
Procedure
Step
Tighten valve. Replace cap or
Using 3/8" open end wrench,
1.
valve if missing.
remove cap (1). Using valve
core wrench, check that valve
(2) is tight and seated.
Using 7/16" open end
2.
Tighten.
...
wrench, check that stem (3) is
tight.
Replace.
Check that valve cap strap (4)
3.
is not damaged.
Replace if binding.
Pull out and check knob (5)
4.
turns from stop to stop
without binding.
Tighten. Replace if missing.
Using spanner wrench, check
5.
that screw (6) is tight.
Clean. Replace knob assembly
Check markings on scale (7)
6.
if scale cannot be read after
can be read.
cleaning.
Tighten. Replace if missing.
...
7.
Using # 1 Phillips screwdriver,
check that four screws (8) are
tight.
8.
Using 3/8" open end wrench,
install valve cap (1) on valve
stem (3).
GO TO FRAME 6
Vol II
3-18