C 1, TM 9-1240-318-35
APPENDIX B
REPAIR PARTS AND SPECIAL TOOLS LIST
Section I. INTRODUCTION
B-1. Scope
(1)
Source code, indicates the selection
status and source for the listed item. Source codes used
This appendix lists repair parts and support equipment
are-
required for the performance of direct support, general
support, and depot maintenance of telescope M120 and
Code
Explanation
telescope XM134.
P
Repair Parts, Special Tools and Test Equipment
B-2. General
supplied from the GSA/DSA or Army supply
system authorized for use at indicated
This Repair Parts and Support Equipment List is divided
maintenance categories.
into the following sections:
P2
Repair Parts, Special Tools and Test Equipment
a. Repair Parts - Section II. A
list of
repair parts for
purposes because the combat or military
the performance of maintenance at the direct support,
essentiality of the end item dictates that a
general support, and depot level in figure and item
minimum quantity be available in the supply
number sequence; illustrations are in disassembly
system.
sequence.
P9
Assigned to items which are NSA design
controlled: Unique repair parts, special, tools, test,
measuring and diagnostic equipment, which are
support equipment authorized for the performance of
stocked and supplied by the Army COMSEC
maintenance at the direct support, general support, and
Logistic System and which are not subject to the
depot level.
provisions of AR 380-41.
P10 Assigned to items which are NSA design
Note. Special tools and test equipment not
controlled: Special Tools, test, measuring and
applicable.
diagnostic equipment for COMSEC support, which
are accountable under the provisions of AR 380-
c. Federal Stock Number and Reference Number
41, and which are stocked and supplied by the
Army COMSEC Logistic System.
followed by reference numbers in ascending alpha-
M
Repair Parts, Special Tools and Test Equipment
numeric sequence, cross-referenced to figure number
which are not procured or stocked, as such, in the
and item number.
supply system but are to be manufactured at
indicated maintenance levels.
B-3. Explanation of Columns
A
Assemblies which are not procured or stocked, as
such, in the supply system but are made up of two
The following provides an explanation of columns in the
or more units. Such component units carry
individual stock numbers and descriptions, are
procured and stocked separately and can be
a. Source, Maintenance, and Recoverability Codes
assembled to form the required assembly at
(SMR), Column 1:
indicated maintenance categories.
X
Parts and assemblies that are not procured or
stocked because the failure rate is normally below
that of the applicable end item of component. The
failure of such part or assembly should result in
retirement of the end item from the supply system.
B-1