*TM 9-1240-314-35P
TECHNICAL MANUAL
HEADQUARTERS
DEPARTMENT OF THE ARMY
No. 9-1240-314-35P
WASHINGTON , D.C. 10 July 1970
DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE REPAIR PARTS
AND SPECIAL TOOLS LIST PERISCOPE, TANK: M36 (1240-980-9291)
SECTION I. INTRODUCTION
Code
Explanation
1. Scope
P2
Repair parts which are procured and stocked for
This manual lists repair parts, special tools, and
insurance purposes because the combat or military
test and support equipment required for the per-
essentiality of the end item dictates that a mini-
formance of direct support, general support, and
mum quantity be available in the supply system.
depot maintenance of Periscope M36.
P9
Assigned to items which are NSA design controlled:
unique repair parts, special tools, test, measuring
and diagnostic equipment, which are stocked and
2. General
supplied by the Army COM SEC logistic system,
and which are not subject to the provisions of AR
This Repair Parts and Special Tools List is
380-41.
divided into the following sections:
P10
Assigned to items which are NSA design controlled:
special tools, test, measuring and diagnostic equip-
parts authorized for the performance of main-
ment for COMSEC support, which are accountable
under the provisions of AR 380-41, and which are
tenance at the direct support, general support,
stocked and supplied by the Army COMSEC logis-
and depot level in figure and item number se-
tic system.
quence; illustrations are in disassembly sequence.
Repair parts which are not procured or stocked, but
M
b. Special Tools, Test, and Support Equipment
are to be manufactured in indicated maintenance
levels.
support equipment authorized for the perform-
Assemblies which are not procured or stocked as
A
such, but are made up of two or more units. Such
ance of maintenance at the direct support, general
component units carry individual stock numbers
support, and depot level,
and descriptions, are procured and stocked se-
c. Federal Stock Number and Reference Num-
parately and can be assembled to form the required
assembly at indicated maintenance categories.
numbers in ascending numerical sequence fol-
Parts and assemblies which are not procured or
X
stocked and the mortality of which normally is
lowed by a list of reference numbers in ascending
below that of the applicable end item or component.
alpha-numeric sequence, cross-referenced to the
The failure of such part or assembly should result
illustration figure number and item number.
in retirement of the end item from the supply sys-
tem.
3. Explanation of Columns
X1
Repair parts which are not procured or stocked. The
requirement for such items will be filled by use of
The following provides an explanation of
the next higher assembly or component.
X2
Repair parts which are not stocked. The indicated
a. Source, Maintenance, and Recoverability
maintenance category requiring such repair parts
Codes (SMR), Column 1.
will attempt to obtain through cannibalization; if
not obtainable through cannibalization, such re-
(1) Source code, indicates the selection
pair parts will be requisitioned with supporting
status and source for the listed item. Source
codes used are:
Major assemblies that are procured with PEMA
G
Code
Explanation
funds for initial issue only to be used as exchange
P
Repair parts which are stocked in or supplied from
assemblies at DSU and GSU level. These assem-
the GSA/DSA, or Army Supply system are author-
blies will not be stocked above DSU and GSU level
ized for use at indicated maintenance categories.
or returned to depot supply level.
* This manual supersedes TM 9-1240-314-35P, 7 July 1964.
1